2X 2005-M-1 Laminated Pull Solenoid Continuous Duty for WoodMaster Wood Boilers
2X 2005-M-1 Laminated Pull Solenoid Continuous Duty for WoodMaster Wood Boilers
FREE, Fast Shipping on all orders!
Laminated Pull Solenoid for WoodMaster Wood Boilers
This continuous-duty laminated pull solenoid for WoodMaster Wood Boilers delivers reliable actuation in outdoor wood furnace damper systems, referencing part 2005-M-1 in a two-pack quantity.
Overview
The laminated pull solenoid is an electromagnetic actuator that opens and closes the combustion air damper on WoodMaster outdoor wood boilers, providing consistent stroke force under continuous-duty cycles. Intended for heating technicians and wood boiler owners maintaining feed control, this solenoid for WoodMaster Wood Boilers keeps the burn cycle stable season after season.
Built For Performance
- Laminated steel frame channels magnetic flux for cooler operation during extended hold times
- Continuous-duty coil rating prevents overheating when the damper stays energized
- Pre-set stroke length matches WoodMaster damper linkage travel
- Corrosion-resistant plunger finish withstands condensation inside the boiler cabinet
- Low-current draw reduces load on the boiler control circuit
Fits These Machines
- for WoodMaster Wood Boilers with damper-actuated air control
- for WoodMaster 3300, 4400, and 5500 series outdoor furnaces
On-The-Job Use
- Replacing a solenoid that fails to pull the damper open during a call for heat
- Seasonal boiler service to restore automatic draft regulation
- Upgrading an older single-stroke solenoid to a laminated continuous-duty design
- Keep a spare on hand to minimize downtime during peak heating months
Specs At A Glance
| Part Number(s) | 2005-M-1 |
| Duty Cycle | Continuous |
| Quantity | 2 solenoids |
| Type | Laminated pull solenoid |
Good To Know
Q: Can this solenoid replace a White-Rodgers 2005-M-1 in non-wood-boiler applications? A: Yes, as long as voltage and stroke specs match, this solenoid cross-references the 2005-M-1 form factor for any continuous-duty pull application.
Q: What voltage does this solenoid operate on? A: It is typically found on 12V or 24V control circuits in wood boiler systems, so verify your specific control board output before installing.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
