2x Front LH ＆ RH Air Suspension Height Level Sensors For 12-18 Audi A6 A8 S7 S8

Front Air Suspension Height Level Sensors for Audi

This pair of front air suspension height level sensors monitors ride height and sends position data to the suspension control module on 2012–2018 Audi A6, A8, S7, and S8 models; they replace factory sensors to restore accurate leveling and damping.

Overview

The front air suspension height level sensors are designed to match the mounting arms and electrical connectors of the original Audi units. By measuring the angle of the control arms, they tell the air suspension module the exact vehicle height so it can inflate or deflate each air spring as needed. These sensors are commonly replaced when a failing sensor triggers a ride height warning light, causes uneven vehicle height, or leads to a loss of adaptive damping.

Built For Performance

• Precision resistive element provides a smooth, linear voltage output across the full suspension travel
• Weather-sealed connector and housing resist moisture, dirt, and road salt
• Supplied as a matched left+right pair so both sides read identically
• Heavy-duty linkage arm with a ball joint that clips onto the factory control arm without modification
• Shipped with the correct mounting bracket and hardware ready to bolt into the original location

Fits These Machines

• for Audi A6 (2012–2018)
• for Audi A8 (2012–2018)
• for Audi S7 (2012–2018)
• for Audi S8 (2012–2018)

On-The-Job Use

• Replacing a sensor when the air suspension warning light appears on the dash
• Solving a vehicle that sits uneven or sags overnight after one sensor fails
• Completing a full air suspension overhaul after an air spring or compressor replacement
• Diagnosing intermittent suspension warnings before they escalate to a hard fault
• Restoring factory ride height control on a used Audi that has been on lowering links

Specs At A Glance

Good To Know

Q: Do I need to recalibrate the suspension after installing these sensors? A: Usually not – the control module reads the new sensor values automatically, but performing a ride height calibration with a scan tool is good practice.

Q: Is this pair for both sides, and what if I only need one? A: The kit includes a left and a right sensor matched to read the same, but each side can be installed individually if only one has failed.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.