2x Manual Transmission Shift Control Cable For 1996-2000 Toyota RAV4 33821-42070

Manual Transmission Shift Control Cable for Toyota

This two-cable set for Toyota RAV4 (OEM 33821-42070) transfers manual transmission shift lever motion into precise gear engagement.

Overview

The manual transmission shift control cable set replaces worn factory cables on 1996-2000 Toyota RAV4 models, restoring smooth gear changes. Each manual transmission shift control cable is built with a flexible yet sturdy inner core and a protective outer jacket to resist heat and abrasion. Designed for DIY mechanics and professional shops, this pair gives the direct shift feel the RAV4 driving experience demands.

Built For Performance

• Direct-fit design matches OEM routing and mounting points
• Steel inner cable with low-friction liner for effortless shifting
• Resilient outer housing resists engine heat and road debris
• Pre-lubricated internals reduce maintenance needs
• Includes two cables for a complete transmission shift replacement
• Corrosion-resistant end fittings with rubber boots

Fits These Machines

• for Toyota RAV4 1996
• for Toyota RAV4 1997
• for Toyota RAV4 1998
• for Toyota RAV4 1999
• for Toyota RAV4 2000

On-The-Job Use

• Daily driving and commuting shift control
• Off-road and trail use where precise gear changes matter
• Restoration and rebuild projects for vintage RAV4 models
• Transmission overhaul and cable replacement service

Specs At A Glance

Good To Know

Q: Will this cable fit both left-hand drive and right-hand drive RAV4 models? A: These cables are engineered for the 1996-2000 Toyota RAV4 regardless of steering orientation; always verify your existing part number matches 33821-42070.

Q: Do I need to adjust the cable after installation? A: No adjustment is required when installed correctly, as the fixed-length design delivers factory-set shift throw.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.