3/4"NPTF Oil Filter w/ 10 Micron Hydraulic For Tractors Log Splitters CP-752-10

3/4 NPTF Oil Filter with 10 Micron Hydraulic for Tractors and Log Splitters CP-752-10

This 3/4 NPTF spin-on hydraulic oil filter with 10-micron filtration protects hydraulic systems on tractors and log splitters, serving as a direct replacement for CP-752-10 and compatible part numbers.

Overview

The 3/4 NPTF oil filter delivers 10-micron hydraulic filtration for tractor and log splitter systems, capturing fine contaminants that wear pumps and valves. Designed for equipment where clean hydraulic fluid is critical to cycle times and lifting force, this hydraulic oil filter meets the filtration demands of mobile and stationary hydraulic circuits. Operators running splitters, compact tractors, and hydraulic implements rely on this level of filtration to extend component life and maintain consistent pressure.

Built For Performance

• 10-micron media traps silt and microscopic particles that bypass coarser filters
• 3/4 NPTF thread ensures a secure, leak-resistant spin-on connection on standard hydraulic heads
• High-collapse-strength canister withstands cold-start pressure spikes and high-flow demand
• Anti-drainback valve prevents dry starts by retaining oil in the filter between cycles
• Heavy-duty steel housing resists dents and corrosion in field and shop environments
• Replaces OEM and aftermarket cross-references for broad hydraulic system compatibility

Fits These Machines

• For tractors with 3/4 NPTF hydraulic filter heads requiring 10-micron filtration
• For log splitters using spin-on hydraulic return-line filters rated at 10 microns
• For compact utility tractors with open-center hydraulic systems spec’ing CP-752-10 equivalents
• For hydraulic power units and industrial systems where CP-752-10 is listed as a replacement

On-The-Job Use

• Return-line filtration on tractor loaders and three-point hitch circuits
• Log splitter hydraulic reservoir return lines protecting the cylinder and valve
• Scheduled hydraulic service intervals where 10-micron cleanliness is specified
• Replacing plugged or damaged filters on machines operating in dusty or wood-chip-heavy yards

Specs At A Glance

Good To Know

Q: What does the 10-micron rating mean for tractor and log splitter hydraulic systems? A: It means the filter captures particles as small as 10 microns, preventing silt-sized contaminants from scoring cylinder bores, spool valves, and pump internals that cause sluggish operation and costly repairs.

Q: How often should a CP-752-10 hydraulic filter be changed on a log splitter? A: Replacement is typically recommended after the first 50 hours on new equipment and every 100 to 200 hours thereafter, though dusty conditions or dark, burnt-smelling fluid indicate a shorter interval is needed.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.