3.5L Head Gasket Set For 07-10 Dodge Magnum Charger Avenger Journey Chrysler 300

3.5L Head Gasket Set for Dodge, Chrysler

This 3.5L head gasket set seals the cylinder head to the engine block on 2007-2010 Dodge Magnum, Charger, Avenger, Journey, and Chrysler 300 models with the 3.5L V6 engine, preventing combustion gas leaks, coolant loss, and oil contamination.

Overview

The 3.5L head gasket set provides a durable, multi-layer seal that maintains compression and separates oil and coolant passages. Engineered to fit 2007-2010 Dodge and Chrysler vehicles with the 3.5L V6, this head gasket set restores proper cylinder sealing after cylinder head removal. It helps prevent overheating and engine damage from blown gasket failures.

Built For Performance

• Multi-layer steel design ensures even clamping load and high fatigue strength
• Elastomer coating seals water and oil passages without added sealant
• Laser-cut combustion rings maintain optimal compression sealing
• Heat-treated material resists warping under extreme cylinder head temperatures
• Direct-fit design aligns with OE head bolt patterns and dowel pins
• Tested to meet or exceed OE burst pressure requirements

Fits These Machines

• for Dodge Magnum 3.5L V6 (2007-2010)
• for Dodge Charger 3.5L V6 (2007-2010)
• for Dodge Avenger 3.5L V6 (2007-2010)
• for Dodge Journey 3.5L V6 (2007-2010)
• for Chrysler 300 3.5L V6 (2007-2010)

On-The-Job Use

• Cylinder head gasket replacement after overheating failure
• Engine rebuild or top-end overhaul
• Head removal for valve job or timing belt service
• Blown head gasket diagnosis and repair on 3.5L V6 engines
• Preventive replacement during high-mileage engine refresh

Specs At A Glance

Good To Know

Q: Is this head gasket set compatible with the 3.5L High-Output V6? A: This set fits the standard 3.5L SOHC V6 used in 2007-2010 Dodge and Chrysler platforms; it is not intended for earlier 3.5L High-Output variants.

Q: Do I need to resurface the cylinder heads before installing new head gaskets? A: It is strongly recommended to check the head for flatness and resurface if necessary to ensure proper sealing and prevent premature gasket failure.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.