3 Namura .040 Over Bore Piston Kits for Can-Am Maverick X3 Turbo & Turbo R 75mm

3 Namura .040 Over Bore Piston Kits for Can-Am Maverick X3 Turbo & Turbo R

These piston kits from Namura provide a .040 inch overbore for Can-Am Maverick X3 Turbo and Turbo R engines, offering a reliable solution for engine rebuilds at 75mm bore size.

Overview

This set of three Namura piston kits is built for Can-Am Maverick X3 Turbo and Turbo R models at .040 oversize. Each kit contains a piston, rings, and pin to restore compression after cylinder boring. The 75mm bore dimension matches the overbore for these high-output machines.

Built For Performance

• High-strength aluminum alloy pistons resist fatigue under boost
• Moly-coated skirts minimize wear during break-in and daily use
• Ductile iron rings provide consistent seal and heat transfer
• Complete kit includes wrist pin with retaining circlips
• .040 overbore gives additional wall cleanup for deeper cylinder damage

Fits These Machines

• for Can-Am Maverick X3 Turbo (2017-2023)
• for Can-Am Maverick X3 Turbo R (2022-2023)

On-The-Job Use

• Engine rebuilding after severe cylinder scoring from dust ingestion
• Racing applications requiring fresh piston and ring sets between seasons
• Restoring lost compression in high-mileage turbocharged engines
• Replacing damaged pistons from detonation or pre-ignition events

Specs At A Glance

Good To Know

Q: Can I use these pistons with stock cylinder bores? A: No, the .040 overbore requires your cylinder to be bored and honed to exactly 75.0mm; do not attempt installation into a standard bore cylinder.

Q: Do the kits come with a warranty? A: Namura pistons carry a limited manufacturer warranty against defects in materials and workmanship; inspect all components before installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.