3006-939 Throttle Position Sensor for Arctic Cat M8 2008-2011
3006-939 Throttle Position Sensor for Arctic Cat M8 2008-2011
Couldn't load pickup availability
Throttle Position Sensor for Arctic Cat
This throttle position sensor replaces OEM 3006-939 and reports throttle plate angle to the engine management system on Arctic Cat M8 machines.
Overview
This throttle position sensor for Arctic Cat delivers accurate throttle angle signals to the ECU so fueling and ignition stay dialed in across the rev range. A failed sensor causes poor idle, hesitation, or a limp mode, and this replacement restores clean throttle response. Built as a direct-fit component for the 2008-2011 M8 platform.
Built For Performance
- Direct replacement for OEM part number 3006-939
- Sealed housing resists snow, moisture, and vibration
- Plug-and-play connector matches the factory harness
- Accurate resistance sweep across the full throttle range
- Compact bolt-in body fits the stock mounting location
Fits These Machines
- for Arctic Cat M8 2008
- for Arctic Cat M8 2009
- for Arctic Cat M8 2010
- for Arctic Cat M8 2011
On-The-Job Use
- Trail riding where smooth part-throttle response matters
- Deep powder sessions that demand clean off-idle power
- Mountain climbs where the ECU needs precise throttle data
- Routine sensor replacement during engine service
Specs At A Glance
| Part Number(s) | 3006-939 |
| Part Type | Throttle Position Sensor |
| Connection | Factory-style plug-in connector |
Good To Know
Q: What symptoms point to a bad throttle position sensor? A: Rough idle, flat spots, and stored throttle codes are common signs. A quick resistance check against the service manual confirms it.
Q: Is this a genuine Arctic Cat part? A: This is an aftermarket replacement that cross-references OEM 3006-939. It is not an original factory part.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
