3008-521 Exhaust Gasket for Tiger Shark Daytona 1000 1997

Exhaust Gasket for Tiger Shark

This exhaust gasket for Tiger Shark replaces OEM part 3008-521, sealing the exhaust joint on Daytona 1000 models to prevent leaks.

Overview

This exhaust gasket for Tiger Shark is a replacement sealing component for the Daytona 1000 watercraft. It fits at the exhaust connection point to stop hot gases from escaping and to keep the joint tight under vibration and heat cycling. It suits riders servicing the exhaust system or completing an engine rebuild.

Built For Performance

• Heat-resistant material built to withstand continuous exhaust gas temperatures
• Precise cut to match OEM part 3008-521 for a proper seal
• Compressible construction that conforms to mating surfaces for leak-free sealing
• Resists blowout under vibration and pressure fluctuations
• Direct replacement fitment for the Daytona 1000 exhaust joint

Fits These Machines

• for Tiger Shark Daytona 1000 (1997)

On-The-Job Use

• Exhaust system service and repair
• Engine rebuild and top-end reassembly
• Fixing exhaust leaks and noise at the joint
• Routine gasket replacement during maintenance

Specs At A Glance

Good To Know

Q: Can I reuse the old exhaust gasket? A: Exhaust gaskets are generally single-use, and reusing a compressed or heat-cycled gasket can lead to leaks. Replacing it during exhaust work helps ensure a reliable seal.

Q: Should I check the mating surfaces before installing? A: Clean, flat mating surfaces are important for a proper seal, so remove old gasket residue and inspect for warping or damage before fitting the new gasket.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.