3012LT Ring Set 76.50mm for Wiseco

Ring Set for Wiseco

This Wiseco 3012LT ring set is a 76.50mm piston ring replacement engineered to restore compression in high-performance four-stroke engines.

Overview

The Wiseco 3012LT Ring Set is a 76.50mm piston ring set made to seal the combustion chamber and keep compression where it belongs. This ring set suits riders and builders refreshing a top end on a Wiseco piston equipped engine. Order this Wiseco ring set when it is time to bring cylinder sealing back to spec.

Built For Performance

• 76.50mm bore sizing matched to Wiseco piston applications
• Multi-piece ring design for consistent cylinder wall sealing
• Produced under the Wiseco part number 3012LT for easy identification
• Intended for high-compression and performance four-stroke builds
• Sold as a ring set for a complete piston ring replacement

On-The-Job Use

• Top end rebuilds on Wiseco piston kits
• Compression refresh during routine engine service
• Race engine assembly and freshen-ups
• Off-road and motocross engine maintenance

Specs At A Glance

Good To Know

Q: Is a ring file or gap check needed before install? A: Ring end gaps should always be verified against your piston and cylinder spec before assembly, especially on performance builds. Q: Can I reuse my old cylinder with these rings? A: Reuse depends on cylinder condition, so measure bore wear and finish before fitting new rings to avoid poor sealing.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.