Skip to product information
1 of 2

3020-342 Throttle Position Sensor for Arctic Cat Bearcat 7000 XT 2017-2019

3020-342 Throttle Position Sensor for Arctic Cat Bearcat 7000 XT 2017-2019

Regular price $164.99
Regular price Sale price $164.99
Sale Sold out
Quantity

Throttle Position Sensor for Arctic Cat Bearcat 7000 XT

This throttle position sensor for Arctic Cat Bearcat 7000 XT snowmobiles monitors throttle valve angle and relays that data to the engine management system, carrying the 3020-342 part number.

Overview

This throttle position sensor for Arctic Cat is a direct-fit replacement that keeps your engine management system reading throttle input accurately. The sensor translates throttle plate movement into an electrical signal the ECU uses to adjust fuel delivery and timing. It suits riders maintaining or repairing a Bearcat 7000 XT that needs a dependable throttle position sensor.

Built For Performance

  • Fits the 7000 XT engine platform with a mounting footprint matched to the factory sensor location
  • Sealed housing resists moisture and snow intrusion common in deep powder riding
  • Electrical connector matches the factory harness plug for a straightforward swap
  • Internal contacts built to hold a stable resistance reading through repeated throttle cycles
  • Meets the 3020-342 reference number for cross-checking against your original part

Fits These Machines

  • for Arctic Cat Bearcat 7000 XT, 2017
  • for Arctic Cat Bearcat 7000 XT, 2018
  • for Arctic Cat Bearcat 7000 XT, 2019

On-The-Job Use

  • Trail riding where consistent throttle response matters to engine smoothness
  • Utility work with the Bearcat's cargo and tow capabilities
  • Cold-start conditions where accurate idle control depends on throttle position input
  • Routine replacement when a fault code points to the throttle position circuit

Specs At A Glance

Part Number(s) 3020-342
Machine Arctic Cat Bearcat 7000 XT
Model Years 2017 to 2019
Type Throttle Position Sensor

Good To Know

Q: How do I know the throttle position sensor needs replacing? A: Common signs include erratic idle, hesitation under acceleration, or a diagnostic code tied to the throttle position circuit. A resistance check against the specified values confirms whether the sensor is within range.

Q: Does this sensor need calibration after installation? A: Most installations only require cycling the ignition so the ECU relearns the throttle closed and open positions. Follow the service procedure for your Bearcat 7000 XT to confirm the reading is correct.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details