3082937 Water Manifold Gasket for Polaris SLT 750 1994-1995

Water Manifold Gasket for Polaris

This water manifold gasket for Polaris replaces OEM part number 3082937 and seals the joint between the manifold and the engine to stop coolant leaks.

Overview

This water manifold gasket is a direct replacement sealing component for the cooling system on Polaris watercraft. The gasket for Polaris sits between the water manifold and the engine surface, holding a tight seal so coolant flows where it should instead of weeping onto surrounding parts. It is made for riders servicing a 1994 to 1995 SLT 750 who need a dependable seal without hunting down an obsolete part number.

Built For Performance

• Cross-references OEM part number 3082937
• Precision-cut to match the manifold mounting footprint
• Seals coolant passages against leaks under pressure
• Built to withstand constant exposure to coolant and engine heat
• Simple bolt-on replacement with no modification required

Fits These Machines

• for Polaris SLT 750 (1994-1995)

On-The-Job Use

• Cooling system service and manifold replacement
• Leak repair at the manifold mounting surface
• Engine rebuilds and top-end reassembly
• Routine maintenance on older Polaris watercraft

Specs At A Glance

Good To Know

Q: Should I replace this gasket every time the manifold comes off? A: Yes, gaskets are single-use sealing components and should be replaced any time the manifold is removed to prevent leaks. A: Reusing a compressed gasket can allow coolant to seep past the sealing surface.

Q: Does this gasket need sealant during installation? A: Many installers fit it dry since the gasket is designed to seal on its own once torqued to spec. Follow your service manual for the correct torque sequence and any sealant recommendation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.