3110KA Ring Set 79.00mm for Wiseco Piston Rings

Ring Set for Wiseco

This 79.00mm ring set is a piston ring replacement kit designed to seal the combustion chamber and control oil on high-performance engines.

Overview

This 79.00mm ring set delivers a precise fit for pistons running a 79.00mm bore. The ring set is built for riders and builders who need fresh compression sealing during a top-end rebuild. Each ring set is sized to match the listed bore so piston-to-cylinder sealing stays consistent.

Built For Performance

• 79.00mm bore sizing for a direct match to the listed piston diameter
• Multi-ring set construction covering compression and oil control duties
• Precision-formed ring faces for consistent cylinder wall contact
• Suitable for high-compression and performance engine builds
• Sold as a complete ring set for one piston

On-The-Job Use

• Top-end rebuilds where the piston is replaced or re-ringed
• Performance engine assembly requiring a specific bore size
• Refresh of compression after ring wear or cylinder work
• Shop and garage rebuilds on single-cylinder and multi-cylinder engines

Specs At A Glance

Good To Know

Q: How many rings are included in this set? A: A ring set for one piston typically includes the compression and oil control rings, so order per piston you are rebuilding.

Q: Do I need to check bore size before ordering? A: Yes, the 79.00mm figure must match your piston and finished cylinder bore exactly for correct ring seating.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.