3110TD Ring Set 79.00mm for Wiseco Piston Rings

Ring Set for Wiseco

This Wiseco ring set, 79.00mm, is a replacement piston ring set for high-performance top-end rebuilds using the 3110TD profile.

Overview

Wiseco ring set, 79.00mm, is a piston ring set made for rebuilding the top end of a performance engine. This ring set, 79.00mm, seals combustion pressure and controls oil between the piston and cylinder wall for consistent compression. It suits riders and builders refreshing a worn top end with the 3110TD ring set.

Built For Performance

• 79.00mm bore sizing for a matched fit to the piston
• Ring set includes the compression and oil control rings
• Made for high-compression, high-rpm engine builds
• Replacement part number 3110TD for easy reference
• Suited to forged piston top-end rebuilds

On-The-Job Use

• Top-end rebuilds on performance engines
• Piston and ring replacement during a rebuild
• Restoring compression on a worn top end

Specs At A Glance

Good To Know

Q: Is this an original equipment part? A: No, this is a replacement ring set and is not an original equipment part. Q: Do I need to gap the rings? A: Ring end gap should be checked and set to your engine builder's specification before installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.