3150LK Ring Set 80.00mm for Wiseco

Ring Set for Wiseco

This 80.00mm piston ring set is designed for use with compatible Wiseco pistons, replacing worn rings to restore compression and engine sealing.

Overview

This 80.00mm ring set is built to pair with compatible Wiseco piston applications, delivering a fresh seal between piston and cylinder wall. It suits riders and builders refreshing a top end who need rings sized correctly for an 80.00mm bore. Installing this ring set helps restore compression and reduce blow-by in a rebuilt engine.

Built For Performance

• 80.00mm bore sizing for a direct fit in matching cylinders
• Ring set configuration sized for a single piston
• Steel construction built to handle combustion heat and pressure
• Precision sizing to support consistent cylinder wall contact
• Designed for use with compatible Wiseco piston applications

On-The-Job Use

• Top end rebuilds and piston replacement
• Routine engine refresh after cylinder wear
• Restoring compression in a worn engine
• Race and performance engine builds

Specs At A Glance

Good To Know

Q: How do I know this ring set fits my piston? A: Confirm the piston bore and ring groove dimensions match the 80.00mm specification before ordering. Cross-check the part number against your piston application.

Q: Can these rings be reused after installation? A: Rings are designed for one-time installation and should be replaced once removed. Reusing them can compromise sealing.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.