3227KD Ring Set 82.00mm for Wiseco Piston Rings

Ring Set for Wiseco

3227KD ring set with an 82.00mm bore diameter, made to seal and control oil on Wiseco pistons during a top end rebuild.

Overview

This Wiseco 3227KD ring set covers one piston at an 82.00mm bore and is intended for engine builders and riders doing a ring replacement or rebuild. The 82.00mm ring set restores cylinder sealing so compression and oil control return to spec. Order this 82.00mm ring set when servicing a compatible Wiseco piston.

Built For Performance

• 82.00mm bore diameter matched to the corresponding piston size
• Complete ring set for a single piston
• Designed for compression sealing and oil control
• Built to Wiseco ring tolerances for repeatable fit
• Intended for performance four-stroke engines

On-The-Job Use

• Top end rebuilds and piston swaps
• Race engine maintenance between rounds
• Re-ring service after cylinder honing
• Recovering lost compression on a tired engine

Specs At A Glance

Good To Know

Q: Can I fit these rings without removing the cylinder? A: No, piston rings are installed on the piston with the cylinder off, so a top end tear down is required.

Q: Will this set work with any 82.00mm piston? A: Ring sets are matched to a specific piston groove and material spec, so confirm the part number against your piston before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.