3228KA Ring Set 82.00mm for Wiseco Piston Rings

Ring Set for Wiseco

3228KA ring set with an 82.00mm bore diameter, designed to refresh the piston ring seal on Wiseco performance pistons.

Overview

This Wiseco 3228KA ring set is built for riders and engine builders replacing worn piston rings during a top end refresh or rebuild. Each 82.00mm ring set restores compression and oil control on compatible Wiseco pistons. Install this 82.00mm ring set whenever the cylinder is honed or the piston is serviced.

Built For Performance

• 82.00mm bore diameter for a precise fit in the matching cylinder
• Multi-piece ring design covering compression and oil control
• Sold as a complete set for one piston
• Manufactured to Wiseco ring specifications for consistent sealing
• Suited to high-compression and high-rpm four-stroke applications

On-The-Job Use

• Top end rebuilds and piston replacements
• Race engine refresh between events
• Restoring compression on a worn or smoking engine
• Cylinder honing and re-ring service

Specs At A Glance

Good To Know

Q: Should rings be replaced when I install a new piston? A: Yes, new rings are normally fitted with every new piston so the seal seats correctly against a freshly honed cylinder.

Q: Do I need to check ring end gap before assembly? A: Always file-fit and measure end gap to the piston maker's spec, since gap requirements change with the application.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.