3268KA Ring Set 83.00mm for Wiseco

Ring Set for Wiseco

This 83.00mm piston ring set is a replacement ring kit intended to restore compression and oil control in a rebuilt or refreshed top end.

Overview

This 83.00mm ring set gives engine builders a direct replacement ring package for piston assemblies that use the 83.00mm bore size. The ring set is intended for rebuilds where the piston is being serviced or replaced and fresh rings are needed to seal the cylinder. It suits mechanics, rebuilders, and riders handling top end work on engines that call for an 83.00mm ring set.

Built For Performance

• 83.00mm bore sizing
• Ring set configuration for a single piston
• Intended for top end rebuilds and refresh work
• Sold under the Wiseco 3268KA reference
• Replacement ring package rather than a complete piston kit

Specs At A Glance

Good To Know

Q: Is this a complete piston kit? A: No, this listing is for a ring set only and does not include a piston, pin, or clips.

Q: Does ring end gap need to be checked before assembly? A: Yes, ring end gap should always be measured and adjusted to the engine manufacturer's specification during assembly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.