3484KD Ring Set 88.50mm for Wiseco Engine Piston Rings

Ring Set for Wiseco

This Wiseco 3484KD ring set is an 88.50mm piston ring set made to seal the combustion chamber and control oil in high-performance small engine and powersport builds.

Overview

The Wiseco 3484KD ring set provides 88.50mm rings for rebuilds and top-end service on single-cylinder engines. This ring set suits engine builders and riders who want reliable compression sealing after a fresh bore or hone. When a Wiseco piston assembly needs new rings, this 88.50mm ring set keeps the top end sealing properly.

Built For Performance

• 88.50mm ring size matched to the corresponding piston bore
• Wiseco 3484KD part number stamped for straightforward identification
• Multi-ring set covering compression and oil control
• Built for high-performance small engine and powersport use
• Intended for rebuild and top-end refresh work
• Supplied as a complete matched group for one piston

On-The-Job Use

• Top-end rebuilds on small single-cylinder engines
• Piston replacement jobs where the bore needs fresh sealing
• Powersport and kart engine refresh work
• Workshop service where ring wear causes low compression

Specs At A Glance

Good To Know

Q: How do I verify this ring set fits my piston? A: Confirm the bore size is 88.50mm and that your piston uses the 3484KD ring set before ordering.

Q: Should rings be replaced during a top-end rebuild? A: Yes, ring sets are typically replaced whenever the top end is opened so the new piston seals correctly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.