3484TD Ring Set 88.50mm for Wiseco Engine Piston Rings

Ring Set for Wiseco

This Wiseco 3484TD ring set is an 88.50mm piston ring set designed to seal the combustion chamber and control oil on high-performance small engine and powersport applications.

Overview

The Wiseco 3484TD ring set delivers 88.50mm rings for rebuilds and top-end service on single-cylinder engines built for performance use. This ring set suits riders and engine builders who want dependable compression sealing in a fresh bore or hone job. For anyone refreshing a Wiseco piston assembly, this 88.50mm ring set keeps the top end sealing the way it should.

Built For Performance

• 88.50mm ring size matched to the corresponding piston bore
• Wiseco 3484TD part number stamped for straightforward identification
• Multi-ring set covering compression and oil control
• Designed for high-performance small engine and powersport use
• Suited to rebuild and top-end refresh work
• Ring set supplied as a complete matched group for one piston

On-The-Job Use

• Top-end rebuilds on small single-cylinder engines
• Piston replacement jobs where the bore needs fresh sealing
• Powersport and kart engine refresh work
• Workshop service where ring wear causes low compression

Specs At A Glance

Good To Know

Q: How do I know this ring set fits my piston? A: Confirm the bore size is 88.50mm and that your piston takes the 3484TD ring set before ordering.

Q: Can I reuse rings after removing a piston? A: Ring sets are normally replaced whenever the top end is opened, since used rings may not reseal correctly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.