35433XR Ring Set 90.00mm for Wiseco Engine Piston Rings

Ring Set for Wiseco

This 90.00mm ring set provides the piston ring sealing needed for a top-end rebuild, with the sizing referenced from the part number 35433XR.

Overview

This 90.00mm ring set supplies the piston rings required to restore compression in a rebuilt or refreshed engine. The 90.00mm ring set is made for riders and engine builders who need a correctly sized sealing set for their piston. Each ring set is sized to 90.00mm to match the piston bore it serves.

Built For Performance

• 90.00mm bore sizing for a matched piston fit
• Ring set configuration for a complete top-end seal
• Steel construction built for combustion chamber sealing
• Sized specifically to the listed bore diameter
• Reference number 35433XR for identification

On-The-Job Use

• Top-end rebuilds on small engines
• Piston replacement service work
• Ring replacement during a compression refresh
• Engine repair projects requiring correct bore sizing

Specs At A Glance

Good To Know

Q: How do I know this ring set matches my piston? A: Confirm that your piston and cylinder bore are sized to 90.00mm before ordering this ring set. Ring sizing depends on the piston and bore, so verify those measurements first.

Q: Is this ring set sold as a full set? A: It is offered as a ring set for the listed 90.00mm size. Check your engine's ring count requirement against the set before installing.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.