3701XR Ring Set 94.00mm for Wiseco Piston Rings

Ring Set, 94.00mm for Wiseco

The 94.00mm Ring Set for Wiseco is a piston ring set that seals compression and manages oil control inside the cylinder. It is intended for engine builders and riders completing a top end rebuild where the bore measures 94.00mm.

Overview

This 94.00mm Ring Set for Wiseco provides the rings required to finish a piston installation at a 94.00mm bore. The rings are sized to the piston groove and cylinder they were engineered for. It is aimed at mechanics and riders restoring sealing on a worn or freshly built top end.

Built For Performance

• 94.00mm bore size matched to the specified piston
• Set includes the compression and oil control rings for one piston
• Produced to Wiseco ring specifications for reliable sealing
• Tension and material selected for performance engine demands
• Supplied as a complete set for a single piston installation

On-The-Job Use

• Top end rebuilds on performance off road and ATV engines
• Reassembly after cylinder honing or replating
• Race engine builds needing consistent ring seal
• Replacement of worn or damaged rings during service

Specs At A Glance

Good To Know

Q: How do I confirm this ring set matches my piston? A: Compare the bore size and part number against the piston being installed, as ring sets are made for a specific bore and groove profile. Verify the piston number first.

Q: Should ring end gap be checked before assembly? A: Yes, end gap and groove clearance should be measured during assembly to confirm the rings suit the cylinder. This helps avoid compression loss or binding.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.