3741XS Ring Set 95.00mm for Wiseco Piston Rings

Ring Set for Wiseco 3741XS

This Wiseco 3741XS ring set is a 95.00mm piston ring set that seals the combustion chamber and controls oil along the cylinder wall. It is made for engine builders and rebuilders who need rings matched to a 95.00mm bore piston for Wiseco applications.

Overview

This Wiseco 3741XS ring set provides a 95.00mm ring set for piston assemblies that need reliable compression sealing and oil control. The ring set for Wiseco 3741XS is sized to that bore, so it seats on the piston and works against the cylinder wall through heat cycles. It suits rebuilders and engine shops replacing worn rings on a 95.00mm bore build.

Built For Performance

• 95.00mm ring diameter sized for a matching bore
• Ring set configuration for compression and oil control
• Steel construction built to hold tension under heat
• Designed to seat against the cylinder wall for a consistent seal
• Sold as a set for one piston

On-The-Job Use

• Engine rebuilds where ring sealing has worn
• Top end refreshes on a 95.00mm bore build
• Piston replacement jobs needing new rings
• Shop work where ring end gap is set during assembly

Specs At A Glance

Good To Know

Q: How do I confirm this ring set fits my piston? A: Match the 95.00mm ring diameter to your piston and bore size, and check the ring groove dimensions before ordering. Ring sets are bore and piston specific, so the part number should match what the piston calls for.

Q: Should ring end gap be adjusted before assembly? A: Yes, ring end gap should be measured and set for your application during assembly. Follow the ring manufacturer's gap specification for your bore and intended use.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.