39145-3799 Jet Pump Housing for Kawasaki Ultra 250X 1500 2007-2008

Jet Pump Housing for Kawasaki

This jet pump housing for Kawasaki watercraft houses the impeller and wear ring while channeling thrust water rearward, and it is cross-referenced to OEM part 39145-3799.

Overview

This jet pump housing for Kawasaki is a replacement pump housing intended for the Ultra 250X 1500 jet drive. It provides the structural body that holds the impeller, wear ring, and related pump internals in correct alignment. Riders repairing a 2007 to 2008 Ultra 250X after pump damage or wear will find this jet pump housing a practical replacement.

Built For Performance

• Cast body contoured to the factory pump tunnel and bolt pattern
• Cross-referenced to OEM part number 39145-3799 for easy matching
• Machined bore surfaces for the wear ring and impeller
• Reinforced mounting points that resist vibration and load
• Constructed for repeated freshwater and saltwater use
• Drop-in footprint for the Ultra 250X 1500 pump assembly

Fits These Machines

• for Kawasaki Ultra 250X 1500, 2007-2008

On-The-Job Use

• Replacing a housing damaged by rocks or debris pulled through the pump
• Refreshing the jet drive during off-season maintenance
• Repairing corrosion or cracking found on an older watercraft
• Stocking a spare for personal watercraft repair shops

Specs At A Glance

Good To Know

Q: Is the impeller included with this jet pump housing? A: No, the housing is sold on its own, so reuse or replace the impeller, wear ring, and bearings as needed.

Q: How do I confirm this fits my Ultra 250X? A: Check that your model is the 2007-2008 Ultra 250X 1500 and compare your existing pump part number to 39145-3799 before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.