Skip to product information
1 of 1

4012115 Water Temp Sensor for Polaris Switchback Pro-R 800 2012-2014

4012115 Water Temp Sensor for Polaris Switchback Pro-R 800 2012-2014

Regular price $52.79
Regular price Sale price $52.79
Sale Sold out
Quantity

Water Temperature Sensor for Polaris Switchback Pro-R 800

This water temp sensor for Polaris Switchback Pro-R 800 snowmobiles monitors coolant temperature and relays that reading to the gauge and ECU, matching OEM cross-reference 4012115.

Overview

This water temperature sensor is a direct-fit replacement for the Polaris Switchback Pro-R 800 built from 2012 to 2014. The sensor reads coolant temperature and sends the signal that drives your temperature gauge and engine management logic. It suits riders replacing a failed or inaccurate sensor during routine service or a top-end rebuild.

Built For Performance

  • Threaded body installs in the factory coolant location without adapters
  • Electrical connector matches the stock harness plug for a clean swap
  • Sealed sensing element resists coolant exposure and vibration
  • Calibrated resistance curve delivers accurate temperature readings
  • Compact housing fits the tight space around the water pump and cylinder head

Fits These Machines

  • for Polaris Switchback Pro-R 800 (2012-2014)
  • for Polaris Switchback Pro-R 800 with 4012115 sensor reference

On-The-Job Use

  • Replacing a failed sensor that reads hot or stays cold
  • Cooling system service and coolant flush jobs
  • Top-end rebuilds where the sensor is removed and refitted
  • Diagnosing gauge faults and overheat warnings

Specs At A Glance

Part Number(s) 4012115
Type Water temperature sensor
Application Coolant temperature monitoring
Vehicle Fit for Polaris Switchback Pro-R 800, 2012-2014

Good To Know

Q: Will this sensor work if my gauge reads incorrectly? A: A sensor with a drifted resistance curve is a common cause of inaccurate gauge readings, so replacing it with this unit restores a reliable signal.

Q: Do I need to drain the coolant to install it? A: Yes, coolant should be drained below the sensor location before removal, then refilled and bled after the new sensor is torqued in place.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details