404-1619-32 Float and Fuel Valve for Ski-Doo Summit 800 High Mark 2000-2002

Float and Fuel Valve for Ski-Doo Summit 800 High Mark

This float and fuel valve, bearing part number 404-1619-32, manages fuel level and flow in the carburetor float bowl to keep fueling consistent on your snowmobile.

Overview

This float and fuel valve is a carburetor part that opens and closes fuel inlet as the float moves, holding the bowl level steady for smooth running. Made as a direct-fit replacement for the Ski-Doo Summit 800 High Mark, it brings back reliable fuel metering when the original valve wears or sticks. Anyone servicing a carb on these machines will find this float and fuel valve a practical drop-in part.

Built For Performance

• Needle and seat design meters fuel into the float bowl
• Supports a stable air-fuel mixture under varying load
• Direct-fit replacement for the listed Ski-Doo application
• Built to handle repeated heat cycles
• Restores consistent fueling after wear or contamination

Fits These Machines

• for Ski-Doo Summit 800 High Mark 2000
• for Ski-Doo Summit 800 High Mark 2001
• for Ski-Doo Summit 800 High Mark 2002

On-The-Job Use

• Carburetor rebuilds and fuel system service
• Restoring smooth idle and throttle response
• Routine maintenance on Summit 800 High Mark machines
• Shop or trailside carburetor repair

Specs At A Glance

Good To Know

Q: What does a float and fuel valve do? A: It controls fuel entering the carburetor float bowl, opening and closing as the float moves to hold the fuel level steady. A worn valve can cause flooding or lean running.

Q: How do I know if this valve needs replacing? A: Common signs include fuel overflowing the carburetor, rough idle, or erratic running. Inspecting the needle tip and seat for wear or debris confirms whether replacement is needed.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.