404-1619-32 Float and Fuel Valve for Ski-Doo Summit 800 Renegade 2001

Float and Fuel Valve for Ski-Doo Summit 800 Renegade

This float and fuel valve, bearing part number 404-1619-32, regulates fuel level and flow inside the carburetor float bowl to keep the air-fuel mixture consistent on your snowmobile.

Overview

This float and fuel valve is a carburetor component that controls fuel inlet and shutoff as the float rises and falls, helping your engine run cleanly across the powerband. Built as a direct-fit replacement for the Ski-Doo Summit 800 Renegade, it restores proper fuel metering when the original valve wears or sticks. Riders and mechanics sourcing a dependable float and fuel valve for routine carb service will find it a straightforward swap.

Built For Performance

• Needle and seat design regulates fuel inlet to the float bowl
• Helps maintain a stable air-fuel ratio under load
• Direct-fit replacement for the listed Ski-Doo application
• Construction suited to repeated hot and cold engine cycles
• Restores consistent fueling after wear or contamination

Fits These Machines

• for Ski-Doo Summit 800 Renegade 2001

On-The-Job Use

• Carburetor rebuilds and fuel system service
• Restoring smooth idle and throttle response
• Routine maintenance on older Summit 800 machines
• Trailside or shop carburetor repair

Specs At A Glance

Good To Know

Q: What does a float and fuel valve do? A: It controls fuel entering the carburetor float bowl, opening and closing as the float moves to hold the fuel level steady. A worn valve can cause flooding or lean running.

Q: How do I know if this valve needs replacing? A: Common signs include fuel overflowing the carburetor, rough idle, or erratic running. Inspecting the needle tip and seat for wear or debris confirms whether replacement is needed.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.