41" TURBO 90 DEGREE OIL FEED LINE KIT T4 T3 T04E T60 T70 GT35 GT45 1/8 NPT -4AN

Turbo Oil Feed Line Kit

This 41 inch turbo oil feed line kit delivers filtered oil from the engine block to the turbocharger center housing, with 90 degree fittings and a -4AN hose suited to T3, T4, T04E, T60, T70, GT35, and GT45 style turbos.

Overview

This turbo oil feed line kit supplies the oil your turbocharger needs to lubricate and cool its bearings. The 41 inch hose runs from a 1/8 NPT source to the turbo inlet, and the 90 degree ends help clear tight engine bays. It suits builders and tuners plumbing a fresh turbo setup or replacing a cracked factory feed line.

Built For Performance

• 41 inch length gives enough reach for most front-mount and top-mount turbo layouts
• 90 degree fittings at the ends ease routing around manifolds and engine mounts
• -4AN hose size matches common turbo inlet restrictions
• 1/8 NPT thread on the supply side for standard block and filter adapters
• Kit format includes the hose and fittings needed to complete the feed run
• Compatible with T3, T4, T04E, T60, T70, GT35, and GT45 turbo families

On-The-Job Use

• Plumbing a new turbo build from scratch
• Replacing a worn or leaking factory oil feed line
• Routing oil on top-mount and front-mount turbo setups
• Track and drift cars running T3 or T4 flange turbos
• Garage installs where a longer feed line simplifies routing

Specs At A Glance

Good To Know

Q: Does this kit work with any turbo flange? A: It is aimed at T3, T4, T04E, T60, T70, GT35, and GT45 style turbos with a 1/8 NPT inlet. Check your turbo's oil inlet thread before ordering.

Q: Are the fittings included? A: Yes, the kit ships with the 90 degree fittings for both ends of the -4AN line. Use fresh crush washers or sealant where the threads require it.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.