4110106 Kill Switch for Polaris Classic 800 2004

Kill Switch for Polaris Classic 800

This kill switch for Polaris Classic 800 replaces OEM part 4110106, cutting ignition instantly when the lanyard is pulled so the engine stops on command.

Overview

This kill switch is a direct-fit replacement for Polaris Classic 800 snowmobiles, giving riders a reliable way to shut down the engine. The tether-style switch for Polaris keeps the motor running only while the clip stays seated, so a fall or separation kills the spark immediately. It suits trail riders and mechanics restoring a 2004 Polaris Classic 800.

Built For Performance

• Direct replacement for OEM part number 4110106
• Tether lanyard design stops the engine the moment the clip is pulled
• Weather-resistant housing suited to cold, snowy conditions
• Simple two-wire hookup matches the factory harness
• Positive contact keeps the ignition circuit closed while the lanyard is seated
• Compact body fits the stock mounting location

Fits These Machines

• for Polaris Classic 800 (2004)

On-The-Job Use

• Trail riding where a quick engine cutoff adds a layer of safety
• Mountain and deep snow riding where falls are common
• Routine replacement of a worn or corroded factory switch
• Restoring a 2004 Polaris Classic 800 to running condition

Specs At A Glance

Good To Know

Q: How does a tether kill switch work? A: The lanyard clip holds the switch closed while attached to the rider; if the rider separates from the machine, the clip pulls free and breaks the ignition circuit. This stops the engine instantly.

Q: Will this plug into my factory harness? A: It is built to replace part 4110106 and connects through the stock wiring on the listed model. Confirm your machine's serial number and connector style before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.