420-2174-25 Connecting Rod Kit for Can-Am Commander 800 2011-2018

Connecting Rod Kit for Can-Am Commander 800

This connecting rod kit is a direct replacement component that connects the piston to the crankshaft, delivering reliable power transfer inside your Can-Am Commander 800 engine.

Overview

This connecting rod kit is made to replace a worn or damaged rod in your Can-Am Commander 800 engine. The connecting rod kit restores the piston-to-crankshaft connection so your side-by-side can run strong again. It suits owners and technicians completing an engine rebuild on the Commander 800.

Built For Performance

• Fits Can-Am Commander 800 models from 2011 through 2018
• Connecting rod kit ships as a matched assembly for the listed engine application
• Manufactured to OEM-style dimensions for accurate bearing and piston alignment
• Built from durable steel alloy for high-load engine duty
• Designed for straightforward installation during engine rebuilds

Fits These Machines

• for Can-Am Commander 800 (2011-2018)

On-The-Job Use

• Engine rebuilds after rod bearing failure
• Top-end service on the Commander 800
• Restoring compression and power output
• Preventive replacement during teardown

Specs At A Glance

Good To Know

Q: Is this connecting rod kit an original Can-Am part? A: No, it is an aftermarket connecting rod kit made to fit the listed Can-Am Commander 800 models and years. Confirm your machine's serial number before ordering.

Q: Do I need to replace other parts at the same time? A: Rod bearings, wrist pin, and related fasteners are commonly replaced during the same job, so inspect them before reassembly. Refer to your service manual for torque specs and procedures.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.