420-4604-95 Intake Mounting Flange for Ski-Doo 2011-2014 Snowmobiles

Intake Mounting Flange for Ski-Doo 420-4604-95

This intake mounting flange, OEM cross-reference 420-4604-95, secures the intake assembly to the engine for Ski-Doo snowmobiles from 2011 through 2014.

Overview

This intake mounting flange provides a solid mounting point for the intake system on Ski-Doo snowmobile engines. It carries the 420-4604-95 reference so buyers can match it to their existing part before ordering. The flange suits riders and mechanics replacing a cracked or warped intake mounting flange on these machines.

Built For Performance

• OEM cross-reference 420-4604-95 for easy match
• Rigid flange body keeps the intake seated under vibration
• Bolt pattern aligned to the factory intake mounting points
• Molded from material suited to engine bay heat
• Replaces a warped or cracked original flange

Fits These Machines

• for Ski-Doo 2011 snowmobiles
• for Ski-Doo 2012 snowmobiles
• for Ski-Doo 2013 snowmobiles
• for Ski-Doo 2014 snowmobiles

On-The-Job Use

• Replacing a damaged intake flange during top-end service
• Curing air leaks at the intake mounting surface
• Intake system reassembly after carburetor or throttle body work

Specs At A Glance

Good To Know

Q: Is this an OEM Ski-Doo part? A: This is an aftermarket intake mounting flange made to match the 420-4604-95 reference and is not an original Ski-Doo part. Q: Do I need gaskets with it? A: A sealing gasket or sealant at the mounting surface is typically used during installation, so check your service manual.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.