420266070 Ignition Coil for Can-Am Commander XT 800 2011-2020

Ignition Coil for Can-Am Commander XT 800

This ignition coil is a replacement spark delivery component cross-referenced to OEM number 420266070 for the Can-Am Commander XT 800.

Overview

This ignition coil replaces the factory coil that fires the spark plugs on the Can-Am Commander XT 800, converting battery voltage into the high voltage needed at the plug. Worn coils cause misfires, hard starting, and rough running under load, so a fresh ignition coil restores dependable combustion on your machine. It is aimed at owners handling their own tune-up and diagnostic work.

Built For Performance

• Cross-references OEM part number 420266070 for direct replacement fit
• Sealed coil body resists moisture, mud, and vibration common to off-road use
• Delivers consistent high-voltage output for reliable spark at the plug
• Plug-and-play connection with the factory wiring harness
• Built to hold output across the heat cycles of the 800 engine

Fits These Machines

• for Can-Am Commander XT 800 (2011 through 2020)

On-The-Job Use

• Replacing a failed coil causing a misfire or no-start condition
• Ignition troubleshooting and tune-up service on side-by-side vehicles
• Restoring smooth idle and full power under trail riding loads
• Scheduled maintenance on high-hour machines

Specs At A Glance

Good To Know

Q: What are the symptoms of a failing ignition coil? A: Misfires, rough idle, hard starting, and power loss under load are the usual signs. Swapping the coil and rechecking spark at the plug confirms whether the coil is the cause.

Q: Is this an original Can-Am part? A: No, this is an aftermarket ignition coil built to fit for Can-Am applications and cross-referenced to OEM 420266070. Match the number on your old coil before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.