420266070 Ignition Coil for Can-Am Maverick 800 2018-2020

Ignition Coil for Can-Am Maverick 800

This ignition coil for Can-Am Maverick 800 provides the high-voltage spark required for reliable combustion, and it cross-references OEM part number 420266070.

Overview

This ignition coil for Can-Am Maverick 800 is a direct-fit replacement that converts low battery voltage into the high-voltage spark needed to ignite the air-fuel charge in the cylinder. It is intended for owners and technicians servicing 2018-2020 Maverick 800 side-by-sides who want a dependable ignition coil for Can-Am at a sensible price. The unit mounts at the factory location and plugs into the existing harness.

Built For Performance

• Cross-references OEM part number 420266070 for easy matching
• Primary and secondary windings engineered for consistent spark output
• Sealed body defends against moisture, dust, and trail vibration
• Factory-style connector mates with the stock wiring harness
• Heat-resistant construction handles continuous engine bay temperatures
• Direct-fit mounting aligns with the original coil position

Fits These Machines

• for Can-Am Maverick 800, 2018-2020

On-The-Job Use

• Replacing a coil that causes misfiring or rough running
• Scheduled ignition maintenance on 2018-2020 Maverick 800 units
• Keeping a spare coil on hand for trail or race day breakdowns
• Restoring crisp throttle response after an ignition fault

Specs At A Glance

Good To Know

Q: What symptoms point to a bad ignition coil? A: Misfires, rough idle, hard starting, and power loss under load are typical. Testing resistance or spark output confirms whether the coil has failed.

Q: Is this an original Can-Am part? A: No, this is an aftermarket ignition coil that cross-references OEM number 420266070. It is not produced by Can-Am.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.