420266070 Ignition Coil for Can-Am Maverick Max 1000 2014-2020

Ignition Coil for Can-Am Maverick Max 1000

This ignition coil for Can-Am Maverick Max 1000 delivers the spark energy needed to fire the engine reliably, and it cross-references OEM part number 420266070.

Overview

This ignition coil for Can-Am Maverick Max 1000 is a direct-fit replacement component that steps up battery voltage into the high-voltage spark your engine needs to ignite the air-fuel mixture. It suits riders and mechanics servicing 2014-2020 Maverick Max 1000 side-by-sides who need a dependable ignition coil for Can-Am without paying original equipment pricing. Built to factory-style dimensions, it installs at the stock mounting points and connects to the existing wiring harness.

Built For Performance

• Cross-references OEM part number 420266070 for straightforward replacement
• Wound primary and secondary coils deliver consistent spark energy across the rev range
• Sealed housing resists moisture, dust, and vibration from off-road use
• Stock-style connector plugs into the factory harness without modification
• Constructed with heat-resistant materials for sustained engine bay temperatures
• Direct-fit mounting matches the original coil footprint

Fits These Machines

• for Can-Am Maverick Max 1000, 2014-2020

On-The-Job Use

• Replacing a weak or failed coil that causes misfires or hard starting
• Routine ignition tune-ups on high-hour Maverick Max 1000 machines
• Trailside or shop repairs where a known-good spare coil is needed
• Restoring smooth idle and clean throttle response after coil failure

Specs At A Glance

Good To Know

Q: How do I know if my ignition coil needs replacing? A: Common signs include misfires, rough idle, hard starting, and reduced power under load. A coil that fails a resistance or spark test should be replaced.

Q: Is this an original Can-Am part? A: No, this is an aftermarket ignition coil that cross-references OEM number 420266070. It is not manufactured by Can-Am.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.