420430624 Cam Chain Plug Gasket for Sea-Doo Wake 215 1503 2008-2009

Cam Chain Plug Gasket for Sea-Doo

This cam chain plug gasket seals the cam chain access plug on the 1503 engine, cross-referencing OEM part 420430624, to keep oil contained and contaminants out.

Overview

This cam chain plug gasket for Sea-Doo is a direct-fit sealing component for the 1503 engine used in the Wake 215 platform. It seats at the cam chain plug location to prevent oil seepage and protect the timing chain cavity from water and debris intrusion. Ideal for riders performing routine engine maintenance or replacing a worn, weeping seal.

Built For Performance

• Precisely formed to match the 1503 cam chain plug seat for a tight, reliable seal
• Constructed from oil-resistant material suited to continuous marine engine heat cycles
• Cross-references OEM part number 420430624 for straightforward identification
• Compact, lightweight design simplifies installation during top-end service
• Helps maintain correct oil pressure by preventing leaks at the cam chain access point

Fits These Machines

• for Sea-Doo Wake 215 (2008-2009)
• for Sea-Doo models equipped with the 1503 engine

On-The-Job Use

• Cam chain plug resealing during engine rebuilds
• Routine maintenance to stop oil weeping at the timing chain access point
• Replacement of a hardened or leaking factory gasket
• Pre-season inspection and refresh of engine sealing components

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: No, this is an aftermarket cam chain plug gasket for Sea-Doo that cross-references OEM number 420430624. Always verify your engine and part number before ordering.

Q: How often should a cam chain plug gasket be replaced? A: Replace it whenever the cam chain plug is removed or if you notice oil seepage around the plug area. Reusing a compressed gasket can lead to leaks.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.