420664049 Camshaft Position Sensor for Can-Am Outlander Max XT 500 2007-2009

Camshaft Position Sensor for Can-Am Outlander Max XT 500

This camshaft position sensor for Can-Am Outlander Max XT 500 delivers the timing signal your engine management system needs to fire the ignition and fuel injection at the right moment, and it carries the OEM cross-reference 420664049.

Overview

This camshaft position sensor for Can-Am Outlander Max XT 500 supplies the ECU with precise camshaft rotation data so spark and fuel delivery stay synchronized across the rev range. It is built for riders maintaining a 2007 to 2009 Outlander Max XT 500 who want a dependable replacement rather than a dealer-only part. The camshaft position sensor installs at the original mounting point and connects with the factory harness.

Built For Performance

• Direct replacement for OEM part number 420664049
• Solid-state Hall-effect sensing element for stable signal output
• Sealed connector body resists water, mud, and dust intrusion
• Heat-resistant housing handles sustained engine bay temperatures
• Plug-and-play wiring connection with no splicing required

Fits These Machines

• for Can-Am Outlander Max XT 500 (2007-2009)
• for Can-Am Outlander 500 applications using part 420664049

On-The-Job Use

• Restoring ignition timing after a no-start or hard-start condition
• Replacing a failed sensor that sets a camshaft position fault code
• Routine maintenance on high-hour trail and utility machines
• Repairing rough running or stalling caused by a weak cam signal

Specs At A Glance

Good To Know

Q: Do I need to reprogram the ECU after installing this sensor? A: No reprogramming is normally required, since the sensor only reports camshaft position to the existing ECU. Clear any stored fault codes and take a short test ride to confirm the code stays off.

Q: How can I tell if my camshaft position sensor has failed? A: Common signs include hard starting, stalling, rough idle, and a check engine light with a cam position code. A resistance or signal test at the connector confirms whether the sensor is the cause.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.