420664049 Camshaft Position Sensor for Can-Am Outlander Max XT 800 2007-2012

Camshaft Position Sensor for Can-Am Outlander Max XT 800

This camshaft position sensor for Can-Am Outlander Max XT 800 delivers the timing signal the ECU needs to run ignition and fuel delivery, cross-referencing OEM 420664049.

Overview

This camshaft position sensor for Can-Am Outlander Max XT 800 reads the cam profile and reports it to the engine control unit so spark and injector timing stay correct. It is a direct replacement for the factory 420664049 part and is built for riders running the Outlander Max XT 800. The camshaft position sensor for Can-Am Outlander Max XT 800 suits daily trail use and full engine rebuilds alike.

Built For Performance

• Direct cross-reference for OEM part number 420664049
• Solid-state Hall-effect pickup with no moving contact parts
• Sealed connector body resists mud, water and dust intrusion
• Heat-resistant housing rated for engine bay temperatures
• Plug-and-play wiring that matches the factory harness

Fits These Machines

• for Can-Am Outlander Max XT 800, model years 2007 through 2012

On-The-Job Use

• Restoring spark and fuel timing after an original sensor fails
• Trail rides where a hard start, misfire or no-start is traced to cam signal loss
• Engine rebuilds and top-end service
• Preventive replacement on high-hour machines

Specs At A Glance

Good To Know

Q: How do I know my camshaft position sensor needs replacing? A: Common signs include extended crank time, a no-start condition, misfiring or a stored cam sensor fault code. Swapping in this replacement part is a direct way to test the fix.

Q: Is any reflash or adjustment needed after installation? A: No. The sensor plugs into the factory connector and the ECU reads it as before. Clear any stored fault codes after fitting and verify the engine starts cleanly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.