420664049 Camshaft Position Sensor for Can-Am Outlander XT 500 2007-2009

Camshaft Position Sensor for Can-Am

The Camshaft Position Sensor for Can-Am is a direct-fit replacement sensor that reports camshaft timing to the engine control module, and it cross-references OEM part number 420664049.

Overview

This camshaft position sensor for Can-Am keeps the engine control module informed of camshaft rotation so fuel delivery and ignition timing stay synchronized. It is built as a drop-in replacement for the original sensor and is intended for riders and mechanics servicing Can-Am Outlander XT 500 machines. The camshaft position sensor restores reliable signal output so the engine starts cleanly and runs smoothly.

Built For Performance

• Direct replacement for OEM part number 420664049
• Solid-state sensing element for consistent signal output
• Sealed connector body resists moisture and trail debris
• Heat-resistant housing suited to engine-mounted conditions
• Plug-and-play wiring connection with no splicing required

Fits These Machines

• for Can-Am Outlander XT 500, 2007
• for Can-Am Outlander XT 500, 2008
• for Can-Am Outlander XT 500, 2009

On-The-Job Use

• Replacing a failed sensor that causes hard starting or stalling
• Restoring camshaft signal after a no-start or misfire code
• Routine engine maintenance on Outlander XT 500 machines
• Trailside or workshop repairs where a direct-fit part is needed

Specs At A Glance

Good To Know

Q: Will this sensor need any wiring changes? A: No, it connects through the factory plug with no splicing required. Installation follows the same steps as removing and refitting the original sensor.

Q: How do I know the sensor is the problem? A: A failed camshaft position sensor commonly causes hard starting, stalling, or a stored fault code. Confirming the code before ordering helps ensure the correct part.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.