420664049 Camshaft Position Sensor for Can-Am Outlander XT 650 2007-2009

Camshaft Position Sensor for Can-Am Outlander XT 650

This camshaft position sensor, carrying OEM cross-reference 420664049, reports camshaft position to the engine control module so ignition and fuel timing stay correct on the Outlander XT 650.

Overview

This camshaft position sensor for Can-Am Outlander XT 650 delivers the timing signal the ECU relies on for spark and injector sequencing. Referenced to 420664049, it is a direct-fit replacement aimed at owners of 2007-2009 machines. Swap it in when the original sensor fails and causes hard starting, misfires, or timing codes.

Built For Performance

• OEM cross-reference 420664049 for confident parts matching
• Delivers camshaft position data for correct ignition and injection timing
• Sealed body stands up to mud, water crossings, and engine heat
• Factory-style connector plugs into the original harness
• Direct-fit mounting at the stock sensor location

Fits These Machines

• for Can-Am Outlander XT 650, 2007-2009

On-The-Job Use

• Trail and backcountry riding
• Utility work around the farm or property
• Bringing a high-hour or stored Outlander back into service
• Ignition troubleshooting and scheduled maintenance

Specs At A Glance

Good To Know

Q: What symptoms point to a bad camshaft position sensor? A: Long cranking, stalling, rough running, and a stored camshaft sensor fault code are the usual indicators. If timing-related symptoms appear alongside a code, testing the sensor output is the logical next step.

Q: Is any programming required after installation? A: No, this direct replacement normally drops in without programming. Confirm the connector clicks into place and the mounting hardware is tightened to spec before starting the engine.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.