420664049 Camshaft Position Sensor for Can-Am Renegade 800 2007-2011

Camshaft Position Sensor for Can-Am Renegade 800

The Camshaft Position Sensor for Can-Am Renegade 800, 2007-2011, cross-references OEM part 420664049, and it reads the camshaft's rotation to tell the engine control unit when to fire the ignition and inject fuel.

Overview

This camshaft position sensor for Can-Am Renegade 800 delivers the timing signal the ECU depends on for correct ignition and fuel delivery. Built to the 420664049 specification, it installs in the factory location on the 2007-2011 Renegade 800. It suits riders replacing a failed or intermittent sensor on their machine.

Built For Performance

• Direct replacement for OEM part 420664049
• Housing designed to seat in the factory mounting location
• Wiring connector matches the stock harness plug
• Sealed body resists oil, dirt, and moisture
• Constructed from durable materials for long service life

Fits These Machines

• for Can-Am Renegade 800 (2007-2011)

On-The-Job Use

• Restores camshaft timing signal on the Renegade 800 engine
• Commonly fitted when hard starting or misfire points to a failed sensor
• Used during routine engine diagnostics and repair

Specs At A Glance

Good To Know

Q: How do I know if my camshaft position sensor has failed? A: A failed sensor often causes hard starting, misfires, or a no-start condition, and it can set a diagnostic trouble code. Confirming the fault with a scan tool before ordering is recommended.

Q: Does this sensor need calibration after installation? A: This sensor installs in the factory location and plug into the stock harness without calibration on the listed models. Verify the connector and mounting point match the original part before fitting.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.