Skip to product information
1 of 2

420664049 Camshaft Position Sensor for Sea-Doo GTI SE 155 1503 2008-2016

420664049 Camshaft Position Sensor for Sea-Doo GTI SE 155 1503 2008-2016

Regular price $44.99
Regular price Sale price $44.99
Sale Sold out
Quantity

Camshaft Position Sensor for Sea-Doo GTI SE 155 1503

This camshaft position sensor, OEM cross-reference 420664049, monitors camshaft rotation and reports timing data to the engine management system on 2008-2016 Sea-Doo GTI SE 155 1503 watercraft.

Overview

This camshaft position sensor for Sea-Doo delivers the timing signal the ECU needs to control fuel injection and ignition accurately. The camshaft position sensor is a direct-fit replacement for the original unit on 1503-powered GTI SE 155 models, keeping your engine running clean through the full RPM range. It suits riders and shops servicing 2008-2016 Sea-Doo GTI SE 155 1503 machines.

Built For Performance

  • Direct-fit replacement for OEM part number 420664049
  • Sealed connector and housing resist water intrusion in marine use
  • Solid-state Hall-effect design for stable signal output
  • Withstands continuous vibration and engine heat
  • Simple plug-in installation at the camshaft location

Fits These Machines

  • for Sea-Doo GTI SE 155 1503, 2008-2016

On-The-Job Use

  • Restoring timing signal on GTI SE 155 watercraft with no-start or rough-running symptoms
  • Routine replacement when the original sensor fails a resistance or signal test
  • Diagnostic swap to confirm a camshaft sensor fault code
  • Seasonal maintenance before launching the ski

Specs At A Glance

Part Number(s) 420664049
Type Camshaft position sensor
Application for Sea-Doo GTI SE 155 1503, 2008-2016

Good To Know

Q: What happens if the camshaft position sensor fails? A: A failed sensor can cause hard starting, misfires, or a no-start condition because the ECU loses camshaft timing data. Replacing it with this direct-fit unit restores the signal.

Q: Does this sensor need programming after installation? A: No programming is required on this application; the sensor plugs into the factory connector and works with the existing ECU calibration. Clear any stored fault codes after fitting.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details