420664049 Camshaft Position Sensor for Sea-Doo RXT X 325 1630 2024-2025

Camshaft Position Sensor for Sea-Doo RXT X 325 1630

This camshaft position sensor for Sea-Doo RXT X 325 1630 delivers the timing signal your engine management system needs, cross-referenced to OEM part 420664049 for a precise fit on 2024-2025 models.

Overview

This camshaft position sensor for Sea-Doo is built to report camshaft rotation to the engine control module so fuel delivery and ignition timing stay synchronized. The camshaft position sensor for Sea-Doo RXT X 325 1630 matches OEM 420664049, making it a direct replacement for the original unit. It suits riders and mechanics servicing 2024-2025 RXT X 325 1630 watercraft.

Built For Performance

• Direct cross-reference to OEM part number 420664049
• Sealed housing resists moisture and spray in marine engine bays
• Solid-state sensing element for consistent signal output
• Plug-and-play connector matches the factory harness
• Heat-tolerant construction for sustained high-RPM operation
• Compact body fits the original mounting location

Fits These Machines

• for Sea-Doo RXT X 325 1630, 2024-2025

On-The-Job Use

• Restoring ignition timing after a failed sensor code
• Scheduled maintenance on 1630 ACE engines
• Diagnosing rough running or hard starting symptoms
• Rebuilds and top-end service on RXT X 325 watercraft

Specs At A Glance

Good To Know

Q: Will this sensor need programming after install? A: No, camshaft position sensors of this type are plug-and-play and the ECU reads them once the connector is seated. Clear any stored fault codes and take a short test ride to confirm the signal.

Q: How do I know the sensor has failed? A: Common signs include hard starting, rough idle, misfires, or a check engine light tied to camshaft position. A resistance and signal test against the service manual will confirm before you replace it.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.