420664049 Camshaft Position Sensor for Sea-Doo Speedster 215 1503 2007-2009

Camshaft Position Sensor for Sea-Doo Speedster 215 1503

This camshaft position sensor for Sea-Doo Speedster 215 1503 models (2007-2009) monitors camshaft rotation and sends timing data to the engine management system; cross-references OEM part number 420664049.

Overview

This camshaft position sensor for Sea-Doo Speedster is a direct-fit replacement that keeps ignition and fuel timing dialed in on the 1503 engine. It reads camshaft position and reports it to the ECM so spark and injection events stay synchronized. Ideal for riders and mechanics servicing 2007-2009 Speedster 215 watercraft.

Built For Performance

• Direct cross-reference to OEM part number 420664049
• Sealed housing resists water spray and engine bay moisture
• Plug-and-play connector matches the factory harness
• Solid-state sensing element for consistent signal output
• Heat-resistant body rated for marine engine bay temperatures

Fits These Machines

• for Sea-Doo Speedster 215 with 1503 engine, 2007-2009

On-The-Job Use

• Restoring timing signal on 1503 engines that crank but will not start
• Routine replacement during top-end service or sensor diagnostics
• Getting a Speedster back on the water after a no-spark fault

Specs At A Glance

Good To Know

Q: How do I know if my camshaft position sensor has failed? A: Common signs include hard starting, a check engine light, misfires, or a no-start condition on your 1503 engine. A scan tool reading for camshaft sensor codes confirms the diagnosis before replacing.

Q: Does this sensor need calibration after installation? A: No, this sensor is a plug-and-play replacement that does not require calibration. Install it, clear any stored codes, and the ECM will read the signal immediately.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.