420664049 Camshaft Position Sensor for Sea-Doo Wake 2 x 260 1503 2012

Camshaft Position Sensor for Sea-Doo

This camshaft position sensor, OEM cross-reference 420664049, reads camshaft rotation and sends timing signals to the engine management system on Sea-Doo personal watercraft.

Overview

This camshaft position sensor for Sea-Doo is a direct-fit replacement for the factory unit on 1503 engine platforms. The sensor reports camshaft position and speed to the ECU so ignition and fuel timing stay accurate. It suits riders replacing a failed or intermittent sensor on a 2012 Wake 2 x 260.

Built For Performance

• OEM cross-reference 420664049 for direct fitment
• Sealed connector body resists water and spray intrusion
• Solid-state Hall-effect sensing with no moving parts
• Heat-resistant housing for continuous engine bay exposure
• Plug-and-play installation with factory connector
• Stable signal output across the full RPM range

Fits These Machines

• for Sea-Doo Wake 2 x 260, 2012
• for Sea-Doo models running the 1503 engine platform

On-The-Job Use

• Restoring ignition timing on 1503-powered Sea-Doo craft
• Replacing a sensor that triggers hard starting or misfires
• Routine maintenance on 2012 Wake 2 x 260 models
• Diagnostic troubleshooting of camshaft signal faults

Specs At A Glance

Good To Know

Q: Will this sensor fit my 2012 Wake 2 x 260? A: It is listed for the 1503 engine platform and the 2012 Wake 2 x 260, but serial number variation can affect fitment. Verify your model and engine code before ordering.

Q: Do I need to reset the ECU after installing a new camshaft position sensor? A: In most cases the ECU relearns the signal automatically once the sensor is connected and the engine starts. If a fault code persists, clear it with a diagnostic tool.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.