420664049 Camshaft Position Sensor for Sea-Doo Wake Pro 230 1503 2017

Camshaft Position Sensor for Sea-Doo Wake Pro 230 1503

This camshaft position sensor for Sea-Doo Wake Pro 230 1503 supplies the camshaft timing signal your engine control module relies on, cross-referenced to 420664049.

Overview

This camshaft position sensor for Sea-Doo replaces the factory sensor that reports camshaft rotation to the ECU for correct spark and fuel timing. It is aimed at owners of the 1503-powered Wake Pro 230 from 2017 who need a reliable camshaft position sensor without paying original equipment pricing. Fitting is straightforward at the factory mounting point using the existing connector.

Built For Performance

• Cross-referenced to OEM part number 420664049 for easy verification
• Water-resistant connector shell suits the damp environment of a PWC engine bay
• Non-contact sensing design eliminates wear from rotation
• Rugged housing tolerates engine heat, vibration, and repeated seasonal use
• Installs with the stock connector and bolt location, no adapters needed

Fits These Machines

• for Sea-Doo Wake Pro 230 1503, 2017

On-The-Job Use

• Replacing a sensor that triggered a camshaft or timing fault code
• Servicing the top end during timing chain or valve work
• Troubleshooting hard starting or erratic running on the water
• Keeping a 2017 Wake Pro 230 1503 maintained for the season

Specs At A Glance

Good To Know

Q: Does this sensor require calibration after fitting? A: No calibration is needed; the ECU picks up the camshaft signal as soon as the sensor is connected. Clear any stored codes and confirm timing before heading out.

Q: Is this an original Sea-Doo component? A: This is an aftermarket camshaft position sensor cross-referenced to 420664049, not an original brand part. Check your engine serial number and connector type before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.