420664049 Camshaft Position Sensor for Sea-Doo Wake STD 170 1630 2020-2025

Camshaft Position Sensor for Sea-Doo

This camshaft position sensor for Sea-Doo delivers the timing signal your engine management system depends on, cross-referenced to OEM number 420664049 for a confident replacement.

Overview

This camshaft position sensor for Sea-Doo is a replacement component that tracks camshaft rotation and sends that data to the engine control module for precise ignition and fuel delivery. It is built to match the original 420664049 fit and connection, making it suitable for routine service or troubleshooting a stalled or hard-starting engine. Fitting this camshaft position sensor for Sea-Doo returns proper timing feedback to the ECU.

Built For Performance

• OEM cross-reference 420664049 for direct replacement
• Sealed body stands up to spray, vibration, and heat
• Factory-style connector plugs into the existing harness
• Stable signal output supports consistent ignition timing
• Mounts in the original location with no modifications

Fits These Machines

• for Sea-Doo Wake STD 170 1630 (2020-2025)

On-The-Job Use

• Replacing a faulty cam sensor that triggers a no-start
• Correcting rough idle and misfires on the water
• Routine upkeep on 1630 powered Sea-Doo models

Specs At A Glance

Good To Know

Q: What symptoms point to a bad camshaft position sensor? A: Hard starting, stalling, misfires, and a check engine light with a cam sensor code are typical signs. Scanning for codes first confirms the diagnosis.

Q: Is programming needed after installing this sensor? A: No special programming is usually required, but clearing old fault codes afterward confirms the repair. Disconnecting the battery before the swap is recommended.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.