420664049 Camshaft Position Sensor for Sea-Doo Wake STD NA 1503 2019

Camshaft Position Sensor for Sea-Doo

This camshaft position sensor for Sea-Doo reestablishes the timing signal your engine control module relies on, with OEM cross-reference 420664049 for straightforward replacement.

Overview

This camshaft position sensor for Sea-Doo is a direct replacement component that reports camshaft rotation to the engine management system so ignition and fuel timing stay accurate. Built to match the original 420664049 fit and connector, it serves riders performing routine maintenance or diagnosing a no-start or rough-running condition. Installing this camshaft position sensor for Sea-Doo restores the signal the ECU needs to run the engine correctly.

Built For Performance

• Direct replacement for OEM reference number 420664049
• Sealed housing resists water spray and engine bay heat
• Plug-and-play connector matches the factory harness
• Solid-state sensing element delivers a stable timing pulse
• Compact body fits the original mounting location without modification

Fits These Machines

• for Sea-Doo Wake STD NA 1503 (2019)

On-The-Job Use

• Replacing a failed camshaft sensor after a no-start condition
• Restoring idle quality and smooth acceleration on the water
• Scheduled maintenance on 1503 naturally aspirated engines

Specs At A Glance

Good To Know

Q: How do I know the camshaft position sensor needs replacing? A: Common signs include hard starting, stalling, misfires, and a check engine light with a camshaft sensor fault code. Confirming the code with a scan tool before ordering saves time.

Q: Does this sensor need any programming after installation? A: No programming is typically required, though clearing stored fault codes after the swap helps confirm the fix. Disconnecting the battery before installation is a good safety step.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.