420856520 Oil Pump Screen for Sea-Doo GTR X HO 1503 2019

Oil Pump Screen for Sea-Doo

The Oil Pump Screen for Sea-Doo GTR X HO 1503 models is a pickup filter that screens debris from the oil before it enters the pump, protecting the engine oil circuit on 2019 machines, and it cross-references OEM part 420856520.

Overview

This oil pump screen fits Sea-Doo GTR X HO 1503 watercraft from 2019 and acts as the inlet filter for the engine oil pickup. The oil pump screen captures particles before they can reach the pump and bearings, helping hold steady oil pressure on the 1503 engine platform. It suits riders handling routine maintenance or replacing a clogged or damaged screen.

Built For Performance

• Fine mesh media blocks debris before it reaches the oil pump
• Direct replacement for OEM part number 420856520
• Rugged construction suited to the heat and vibration of marine engine bays
• Restores proper oil pickup flow after a clogged screen is removed
• Sized for the 1503 HO engine oil pump assembly
• Sealed inlet fit helps prevent unfiltered oil bypass

Fits These Machines

• for Sea-Doo GTR X HO 1503, 2019

On-The-Job Use

• Routine oil system servicing on 1503 HO-powered Sea-Doo watercraft
• Replacing a clogged or torn screen found during an oil change
• Preventive maintenance before a riding season
• Engine rebuilds and oil pump reassembly

Specs At A Glance

Good To Know

Q: How often should the oil pump screen be replaced? A: Many riders inspect it at every oil service and replace it when debris buildup or mesh damage is found. Following your owner's manual interval is the safest guide.

Q: Does this screen come with seals or gaskets? A: This listing covers the oil pump screen alone as shown by the listed part number. Check your parts diagram for any o-rings or gaskets needed at the same time.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.