420856520 Oil Pump Screen for Sea-Doo RXT IS 260 1503 2010-2012

Oil Pump Screen for Sea-Doo

This oil pump screen for Sea-Doo RXT IS 260 1503 models filters debris from the oil supply before it reaches the pump, and it cross-references OEM part number 420856520.

Overview

The oil pump screen for Sea-Doo is a pick-up filter mounted at the oil pump inlet to catch shavings, sludge, and other particles before they enter the lubrication circuit. Built for the 1503 engine platform used in 2010 to 2012 RXT IS 260 watercraft, this oil pump screen for Sea-Doo helps maintain steady oil pressure and protects internal engine parts. It is intended for riders and technicians servicing the bottom end or replacing a restricted screen.

Built For Performance

• Fine mesh media captures small debris before it reaches the oil pump
• Rated for hot oil and continuous submersion in the sump
• Direct fitment for the 1503 engine oil pick-up point
• Cross-references OEM part number 420856520 for easy verification
• Helps sustain oil pressure by keeping the pick-up clear
• Serviceable part suited to scheduled maintenance

Fits These Machines

• for Sea-Doo RXT IS 260 1503, 2010-2012

On-The-Job Use

• Routine oil system service and bottom-end inspection
• Engine rebuilds needing a fresh pick-up screen
• Replacing a clogged or damaged screen restricting oil flow
• Preventive maintenance on higher-hour supercharged models

Specs At A Glance

Good To Know

Q: Is a gasket or seal included with this screen? A: This listing covers the oil pump screen itself, so consult your parts diagram for any separate seal or o-ring required at installation. Reusing worn seals is not advised.

Q: When should the screen be replaced? A: Many riders inspect the pick-up screen at oil change intervals or if oil pressure drops. If debris or damage is found, replacing the screen helps protect the engine.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.