420886725 Armature Stator Coil for Sea-Doo HX 720 1995-1997

Stator Coil for Sea-Doo HX 720

This armature/stator coil is a charging and ignition system component that mounts to the engine of the Sea-Doo HX 720 and generates the electrical current required to charge the battery and fire the ignition, with an OEM cross reference of 420886725.

Overview

This stator coil assembly is built for the Sea-Doo HX 720, replacing the original armature that produces charging current and ignition power on the 720 engine. The stator coil for Sea-Doo HX 720 converts engine rotation into usable electrical output, keeping the battery topped up and the ignition system firing reliably across the RPM range. It suits owners and shops repairing a machine that has lost charging output, runs weak, or will not start.

Built For Performance

• Direct-fit armature and stator coil assembly matched to the 720 engine's charging specification
• Coil winding designed to deliver stable output through the 720's operating RPM range
• Cross-referenced to OEM part number 420886725 for accurate replacement
• Insulated and sealed to stand up to moisture, fuel vapor and the vibration of a two-stroke marine engine
• Uses the factory mounting points for a straightforward bolt-on installation

Fits These Machines

• for Sea-Doo HX 720
• for Sea-Doo models equipped with the 720 engine from 1995 to 1997 where the OEM part number matches

On-The-Job Use

• Replacing a failed stator on an HX 720 that no longer charges its battery
• Diagnosing and repairing a no-spark or weak-spark condition traced to the charging coil
• Refreshing the electrical system during a top-end or engine rebuild
• Dealer and DIY repairs where an OEM cross-referenced replacement part is preferred

Specs At A Glance

Good To Know

Q: What are the signs of a bad stator coil? A: A battery that will not stay charged, weak or missing spark, and an engine that cuts out once warm are common signs the stator needs testing and likely replacement.

Q: Will this fit my 720 engine? A: It is made to replace the armature on 720-powered models such as the HX, but confirming the OEM part number 420886725 against your machine before ordering is always recommended.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.