420886725 Armature Stator Coil for Sea-Doo Sportster 650 1995

Armature/Stator Coil for Sea-Doo Sportster 650

This armature and stator coil assembly, reference 420886725, supplies the electrical current your watercraft's ignition and charging system needs to run reliably all day.

Overview

This armature/stator coil is a replacement electrical component built for the Sea-Doo Sportster 650 from 1995. The stator generates the current that powers ignition and recharges the battery, and the armature delivers that output through the system. It suits riders and shops replacing a failed coil or refreshing the charging circuit on a classic Sportster.

Built For Performance

• Stator windings designed for steady charging output across the rev range
• Armature assembly built to resist constant vibration on the water
• Coil insulation rated for heat, moisture, and fuel vapor exposure
• Mounting points matched to the stock stator housing
• Cross-referenced to OEM part number 420886725 for easy verification

Fits These Machines

• for Sea-Doo Sportster 650, 1995

On-The-Job Use

• Bringing charging voltage back on a Sportster that runs its battery flat
• Replacing a shorted or burned stator after an electrical failure
• Pre-season ignition maintenance on a 1995 Sportster 650
• Diagnostic swaps to isolate a no-spark condition

Specs At A Glance

Good To Know

Q: What symptoms point to a bad stator coil? A: A battery that keeps going dead, weak or missing spark, and unstable tach readings are typical. Checking coil resistance against the service manual spec confirms the diagnosis.

Q: Will this fit my 1995 Sportster 650 directly? A: It is cross-referenced to 420886725 and made to fit the listed model and year. Verify the number on your original stator and check your serial number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.